 |
|
| Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work. |
| Reply |
|
|
LinkBack | Thread Tools | Display Modes |
|
#1
Posted to rec.crafts.metalworking
|
|||
|
|||
Southbend Lathe Question
I have just acquired a 10 inch Southbend lathe With a taper attachment. To
engage the taper attachment I assume that the large handle with a screw thread in it is tightened and the cross slide nut disengaged. I am at somewhat of a loss about the cross slide nut. Directly in front of the compound and on the cross slide is steel part about .5 in diameter with a slot in it, also has a oil hole for the nut. How is this disengaged? Unscrew or what? -- Jim |
| Reply |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Slightly older Sears Craftsman lathe question | Woodturning | |||
| Market Research Question -- Sakai ML 360 Lathe | Metalworking | |||
| Dumb Question -- Atlas lathe bearing headplay | Metalworking | |||
| FS 9" Southbend lathe | Metalworking | |||
| Kelton Balancer Review Draft--long | Woodturning | |||
Linear Mode
