 |
|
| Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work. |
|
|
LinkBack | Thread Tools | Display Modes |
|
#1
|
|||
|
|||
module of VW flywheel gear
I am making some plans for my VW generator project. I have to use a
different starter and flywheel than the one that came from the engine. I have been trying to figure out the correct distance between the new flywheel and starter motor. By my rough measurements the pitch diameter of the flywheel is about 276mm and the number of teeth is 132. This results gear module of about 2.1. I was expecting something more standard like 2.0 or 2.5. What gives? stan |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Gear fabrication advise needed | Metalworking | |||
| one-off gear cutting info needed. | Metalworking | |||
| PLEASE HELP !! Toshiba 32ZD08B Stuck in Standby + Green Screen (help locating the Teletext module) | Electronics Repair | |||
| Gear cutting...am I crazy? (long) | Metalworking | |||
| Help a newbie out? | Metalworking | |||
Threaded Mode
