a friend and I picked up a big pile of Minarik controllers last week - I'm
sorting through them now, some are damaged, some appear new, I found a nice
3 phase VFD that I'm now using (but there don't appear to be any more
working ones of that), lots of boards. the controllers I've identified are
all for various types of DC motors. For example, I have sitting here a
couple of the RG500 series and an RG51U.
I'm not going to be able to test all of these, though I may be able to test
some of them - if you are interested, contact me off the list - prices will
vary - "unknown" boards will be $1 to $10, repairable controllers will be
$10 to $20, ("non-repairable" will be cheaper), and anything that I am
reasonably sure will work will be a little more, but never more than half of
list (for a testing and workng one), probably a lot less.

for example, I have a couple of MM2000 controllers (manual is here
http://www.minarikcorp.com/PDFs/250-0089.pdf) that appear to be new - those
will be $35 each

If you have some interest in any of these, contact me off the list by
unmangling my email, below. As I figure out what I really have, they will
go on to E-bay and probably be more expensive.

--
Bill

to Email me, repair this address and use it:
william_ b_ noble at msn dot com

also check out http://www.wbnoble.com