PING: GUNNER- High-Speed Spindle
 

Have you got a 10krpm spindle gathering dust? I need to spin a 6"-7" x
1/16"-3/32" cut-off disk with 1-2 hp. I had bought a Deil (sp) a few years
ago but I can't find it.


The spindle I have in use now is shop-made using Barden bearings. It's not
perfect enough and it's a bit noisy with vibration.

PING: GUNNER- High-Speed Spindle
 

On Sun, 31 Jan 2010 00:44:40 -0500, "Buerste"
wrote:

Have you got a 10krpm spindle gathering dust? I need to spin a 6"-7" x
1/16"-3/32" cut-off disk with 1-2 hp. I had bought a Deil (sp) a few years
ago but I can't find it.


The spindle I have in use now is shop-made using Barden bearings. It's not
perfect enough and it's a bit noisy with vibration.

Nope..I sure dont. But Ill check around. What size arbor/chuck do you
need?

Gunner

Whenever a Liberal utters the term "Common Sense approach"....grab your
wallet, your ass, and your guns because the sombitch is about to do
something damned nasty to all three of them.

PING: GUNNER- High-Speed Spindle
 

Nope..I sure dont. But Ill check around. What size arbor/chuck do you
need?

Gunner


I use a 6" x 1/16" cut-off disk to trim end brushes. 1/2" or 5/8" AH

PING: GUNNER- High-Speed Spindle
 

On Sun, 7 Feb 2010 11:12:31 -0500, "Buerste" wrote:


Nope..I sure dont. But Ill check around. What size arbor/chuck do you
need?

Gunner


I use a 6" x 1/16" cut-off disk to trim end brushes. 1/2" or 5/8" AH


Ill see what I can do.

Gunner

Whenever a Liberal utters the term "Common Sense approach"....grab your
wallet, your ass, and your guns because the sombitch is about to do
something damned nasty to all three of them.