Have you got a 10krpm spindle gathering dust? I need to spin a 6"-7" x
1/16"-3/32" cut-off disk with 1-2 hp. I had bought a Deil (sp) a few years
ago but I can't find it.


The spindle I have in use now is shop-made using Barden bearings. It's not
perfect enough and it's a bit noisy with vibration.

On Sun, 31 Jan 2010 00:44:40 -0500, "Buerste"
wrote:

Have you got a 10krpm spindle gathering dust? I need to spin a 6"-7" x
1/16"-3/32" cut-off disk with 1-2 hp. I had bought a Deil (sp) a few years
ago but I can't find it.


The spindle I have in use now is shop-made using Barden bearings. It's not
perfect enough and it's a bit noisy with vibration.

Nope..I sure dont. But Ill check around. What size arbor/chuck do you
need?

Gunner

Whenever a Liberal utters the term "Common Sense approach"....grab your
wallet, your ass, and your guns because the sombitch is about to do
something damned nasty to all three of them.

Nope..I sure dont. But Ill check around. What size arbor/chuck do you
need?

Gunner


I use a 6" x 1/16" cut-off disk to trim end brushes. 1/2" or 5/8" AH

On Sun, 7 Feb 2010 11:12:31 -0500, "Buerste" wrote:


Nope..I sure dont. But Ill check around. What size arbor/chuck do you
need?

Gunner


I use a 6" x 1/16" cut-off disk to trim end brushes. 1/2" or 5/8" AH


Ill see what I can do.

Gunner

Whenever a Liberal utters the term "Common Sense approach"....grab your
wallet, your ass, and your guns because the sombitch is about to do
something damned nasty to all three of them.