Home |
Search |
Today's Posts |
|
Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
#1
Posted to rec.crafts.metalworking
|
|||
|
|||
Gas dryer broke, tumbles but does not dry.
Hey Iggy,
While there may well be a compnent fault, don't rule out a safety cut-out. Make sure every thing is clean and there is good pre-start airflow, etc. XXXXXXXXXX On Sun, 08 Mar 2009 15:52:14 -0500, Ignoramus32468 wrote: Oddly enough, two weeks after my GE Profile washer broke (which turned to be an easy home fix), now my dryer is broke. This is a about 2.5 years old GE Profile dryer that uses natural gas for heating. This is a relatively high priced piece and I would hazard to guess that it has electronic ignition. The symptom is that it tumbles, but stays cold. There is NO heat whatsoever produced. I am open to any suggestions. Thanks |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Cost to install a new gas dryer (old one broke) | Home Repair | |||
Gas dryer broke, tumbles but does not dry. | Metalworking | |||
Gas dryer broke, tumbles but does not dry. | Metalworking | |||
Cost to install a new gas dryer (old one broke) | Home Repair | |||
sewer snake broke dryer vent pipe?? | Home Ownership |