Wallowed out tie rod end hole on a steering
knuckle on a 4WD John Deere tractor. $1800
part. Got a new tie rod, trying to figure out
the taper so I can get a reamer. It's a ZF
front
axle, so it's probably metric. Does anybody
KNOW what the taper is? Looks really close
to 1 in 12, but is it?

Source for a left hand spiral right hand reamer?

Thanks,

Bill

Reply With Quote

Thread Tools	Search this Thread
Show Printable Version	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Rock drilling tools--DTH hammer and bit, open pit, surface, underground ming, quarrying, tunnelling equipment, drill rod, drag bit, taper rod,taper bit, water well drilling, button bit, thread bit, shank adapter for rock drills, drill tube, drill pip	Jack	Home Ownership	0	May 18th 07 10:06 AM
drill bit,drill rod,core barrel,core drilling tools, drill tube, DTH hammer and bit, drag bit, thread bit, taper bit,taper rod,integral drill rod,drill steel, button bit, shank adapter,extension rod, speed rod, rock drill, handheld ,pneumatic, motor-	[email protected]	Home Ownership	0	September 19th 06 03:57 AM
Rock drilling tools--DTH hammer and bit, open pit, surface, underground ming, quarrying, tunnelling equipment, drill rod, drag bit, taper rod,taper bit, water well drilling, button bit, thread bit, shank adapter for rock drills, drill tube, drill pip	[email protected]	Home Ownership	0	September 13th 06 09:50 AM
2 Morse taper extender to 3 taper, then 1 inch threading die holder	Doug Goncz	Metalworking	5	October 21st 03 12:00 PM

All times are GMT +1. The time now is 08:55 AM.

About Us

"It's about DIY & home improvement"

Menu

About Us