Chicago Pneumatic Impact Gun CP734 Parts
 

I've got one of these older model impact guns that is just not
performing as well as it should. I took a look around for the tune up
kit and the repair kit, but couldn't find anything specific for this
gun. I found a bunch of references to CP734H parts and to CPT734, but
nothing for plain CP734. I don't think the "H" parts will fit. Does
anybody have a source for parts for the older CP734 model? Also, is
there part that typicall goes bad on these guns?

Thanks.

Chicago Pneumatic Impact Gun CP734 Parts
 

On Mon, 01 Oct 2007 10:25:36 -0700, jim wrote:

I've got one of these older model impact guns that is just not
performing as well as it should. I took a look around for the tune up
kit and the repair kit, but couldn't find anything specific for this
gun. I found a bunch of references to CP734H parts and to CPT734, but
nothing for plain CP734. I don't think the "H" parts will fit. Does
anybody have a source for parts for the older CP734 model? Also, is
there part that typicall goes bad on these guns?

Thanks.

Bearings, vanes and trigger springs are the usual culprits. Parts here
about half way down the page.
http://www.parts4tools.com/generic13.html

--Andy Asberry--
------Texas-----

Chicago Pneumatic Impact Gun CP734 Parts
 

On Mon, 01 Oct 2007 16:53:46 -0500, with neither quill nor qualm, Andy
Asberry quickly quoth:

On Mon, 01 Oct 2007 10:25:36 -0700, jim wrote:

I've got one of these older model impact guns that is just not
performing as well as it should. I took a look around for the tune up
kit and the repair kit, but couldn't find anything specific for this
gun. I found a bunch of references to CP734H parts and to CPT734, but
nothing for plain CP734. I don't think the "H" parts will fit. Does
anybody have a source for parts for the older CP734 model? Also, is
there part that typicall goes bad on these guns?

Thanks.

Bearings, vanes and trigger springs are the usual culprits. Parts here
about half way down the page.
http://www.parts4tools.com/generic13.html

If the tool has been sitting for very long, the oil gums up and the
power goes way down. A disassembled soak in solvent, reoiling, and
reassembly usually helps a whole lot. My old Rodac 1/2" impact is
doing that since I haven't used it in decades.

--
Men never do evil so completely and cheerfully as when
they do it from religious conviction. - Blaise Pascal