About Us

Try this page for info:

http://www.lathes.co.uk/craftsman/index.html

Best Regards,
Keith Marshall

"I'm not grown up enough to be so old!"

"Terry G" wrote in message
news

uv5c.37951$506.16113@fed1read05...
I am picking up a craftsman model 101.07403 12" lathe tomorrow and I am a
bit confused on the actual bed length, and the 'between centers'
dimension.

I searched the web and newsgroups for this model lathe and found it to be
called a 12"x24" and a 12"x36" lathe. Does it come in two sizes?

The person I am purchasing it from actually measured the distance between
the front of the 3 jaw chuck (mounted on the headstock) and the front tip
of
the tailstock without anything installed into it. It measured at around
30". So you can see why I am confused. Is this lathe considered to have
24" or 36" between centers. He also stated it has a 40" bed, but I think
he is measuring with a tape measure and not quite sure where to measure
from
since I believe these only came in 42" and 54" beds. The lathe is mounted
on a 60" long table, with about 4 to 6 inches of exposed table (length).
So this leads me to believe the overall length of the lathe is around 54".
I am really confused now.

The only problem with the lathe (which he doesn't consider a problem) is
that the threads on the feedscrew right near the headstock are starting to
show a little wear. He said it should not affect anything, but wanted to
disclose every thing he noticed. Also, there is a bit of backlash on the
carriage. He said by slightly tightening the gibs he can eliminate that
problem. I priced a new leadscrew from sears, just in case it was
really
bad, and they want $543.33. Is there any other source or way to replace
this item if needed.

One last question, I want to put a quick change gearbox on it. Will this
adapt to this lathe since it did not originally come with it?

Thanks for the help. If it looks clean and everything works as stated, I
will be happy. He is letting it go for $600.00. I think it is a fair
price.

Thread Tools	Search this Thread
Show Printable Version	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Craftsman metal lathe model 101.07301	Ludwig P. Pietz	Metalworking	3	March 15th 04 01:09 AM
how do you remove the lead screw gear on a craftsman 109.20630 lathe?	drew j.	Metalworking	2	November 25th 03 06:55 AM
craftsman 109.20630 mini lathe -- my first lathe!! yay!!	drew j.	Metalworking	5	November 22nd 03 12:46 AM
FA: Set of Four Craftsman Lathe Tool Holders	Wally Blackburn	Metalworking	0	September 23rd 03 11:19 PM
FA: Original Craftsman (Atlas) Lathe Tool Holder	Wally Blackburn	Metalworking	0	August 26th 03 05:54 PM

Menu

About Us