Home |
Search |
Today's Posts |
|
Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
#1
Posted to rec.crafts.metalworking
|
|||
|
|||
Jaws for a Rockwell chuck?
Got a little 5 inch 3 jaw chuck. Marked "Rockwell, Made in USA, 25-870"
All it came with is a set of outside jaws, would like to get a standard set. Anyone have any good ideas? Googling didn't turn up much, and I'm not finding any in MSC/J&L/Enco. Thanks, Bill |
#2
Posted to rec.crafts.metalworking
|
|||
|
|||
Jaws for a Rockwell chuck?
Bill Marrs wrote: Got a little 5 inch 3 jaw chuck. Marked "Rockwell, Made in USA, 25-870" All it came with is a set of outside jaws, would like to get a standard set. Anyone have any good ideas? Googling didn't turn up much, and I'm not finding any in MSC/J&L/Enco. The only way you are going to find them is to match them up at a used machinery dealer or hobby show. I have about 50 sets that I don't know what fit but I can't afford to do measurement survey including backside thread pitch and hope I find a $25.00 sized sale. You are not going to find them in any catalog though it might help to determine who made the chuck. Rockwell surely didn't. Leigh @MarMachine |
#3
Posted to rec.crafts.metalworking
|
|||
|
|||
Jaws for a Rockwell chuck?
On Tue, 02 May 2006 21:42:40 GMT, Bill Marrs wrote:
Got a little 5 inch 3 jaw chuck. Marked "Rockwell, Made in USA, 25-870" All it came with is a set of outside jaws, would like to get a standard set. Anyone have any good ideas? Googling didn't turn up much, and I'm not finding any in MSC/J&L/Enco. Bill, I think I have that same chuck, and I don't use it because I also have an 8" 3-jaw for my Rockwell. I'll check tonight, pretty sure I have all the jaws for it. If you don't see email tonight send me a reminder, my address is real. |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Rockwell chuck jaws source? | Metalworking | |||
Making lathe chuck jaws | Metalworking | |||
Teknatool Titan Chuck draft review | Woodturning | |||
Using Brass Round to Lap Chuck Jaws | Metalworking | |||
Backplate stuck on 8" 3 Jaw chuck??? | Metalworking |