How to: Using a Lathe and/or Mill
 

Is anyone aware of any good DVDs or VHS tapes on the subject of using
Lathes and/or Mills?

You can't do any better than visual demonstrations, and there doesn't
seem to be much out there on these subjects.

(And taking a class/course is *not* an option for me).

Thanks a lot.

Darren Harris
Staten Island, New York

How to: Using a Lathe and/or Mill
 

Get the Southbend book. How to operate a Lathe.
Bob AZ

How to: Using a Lathe and/or Mill
 

We used the AGI tapes as instructional material in the machining
classes I taught. Students could check out and watch at home,
and then apply in the lab.

see:
http://www.machineshopcourse.com/

Prices seem a little high, but there is a lot of material
compared to the less expensive tape sets. I understand there are
web sites that will rent you the tapes and you might check to see
if you can obtain on interlibrary loan.

Uncle George


On 21 Jan 2006 13:46:15 -0800, wrote:

Is anyone aware of any good DVDs or VHS tapes on the subject of using
Lathes and/or Mills?

You can't do any better than visual demonstrations, and there doesn't
seem to be much out there on these subjects.

(And taking a class/course is *not* an option for me).

Thanks a lot.

Darren Harris
Staten Island, New York

How to: Using a Lathe and/or Mill
 

"F. George McDuffee" wrote in message
...
We used the AGI tapes as instructional material in the machining
classes I taught. Students could check out and watch at home,
and then apply in the lab.

see:
http://www.machineshopcourse.com/

Prices seem a little high, but there is a lot of material
compared to the less expensive tape sets. I understand there are
web sites that will rent you the tapes and you might check to see
if you can obtain on interlibrary loan.

Uncle George


Google this group for technical rentals. Someone was offering a rental by
mail deal in the last year or two.

How to: Using a Lathe and/or Mill
 

On Sun, 22 Jan 2006 11:32:15 -0500, the renowned "ATP*"
wrote:


"F. George McDuffee" wrote in message
.. .
We used the AGI tapes as instructional material in the machining
classes I taught. Students could check out and watch at home,
and then apply in the lab.

see:
http://www.machineshopcourse.com/

Prices seem a little high, but there is a lot of material
compared to the less expensive tape sets. I understand there are
web sites that will rent you the tapes and you might check to see
if you can obtain on interlibrary loan.

Uncle George


Google this group for technical rentals. Someone was offering a rental by
mail deal in the last year or two.

http://technicalvideorental.com/rental_0.html

Great folks to deal with.



Best regards,
Spehro Pefhany
--
"it's the network..." "The Journey is the reward"
Info for manufacturers: http://www.trexon.com
Embedded software/hardware/analog Info for designers: http://www.speff.com