Home |
Search |
Today's Posts |
|
Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work. |
|
LinkBack | Thread Tools | Display Modes |
#1
|
|||
|
|||
Clearance for chroming
I have two pieces that will eventually be chromed. One will be held
via a shoulder bolt and the other will have pressed in bushings. Neither piece spins. they must rock back and forth at low speed and very light load. Should I allow for chroming when I ream the holes or ream them afterward. If afterward - how much material should I leave or should I ream them to size and then ream them again after chroming. Thanks Jim |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Built in microwave clearance | UK diy | |||
kitchen sink problem: want single-flow crosstop deck sink mixer... but height clearance limited | UK diy | |||
Clearance between router cutter and guide bush ? | UK diy |