 |
|
| Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work. |
|
|
LinkBack | Thread Tools | Display Modes |
|
#1
|
|||
|
|||
Drill/Tap NPT in Brass Boiler
Good Morning -
Thinking about drilling and tapping my espresso machine boiler (top surface) for a thermocouple installation - either 1/16 or 1/8 NPT. While it would be ideal if there were a "boss" that gave me, say, 3/8 or 1/2" wall thickness, I'm thinking that the boiler's top wall is only about 1/8" thick. Any tips/tricks you can think of would be appreciated. Eric S. |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Non-modulating condensing boilers? | UK diy | |||
| Condensing Boiler News | UK diy | |||
| Mixing header and pumps | UK diy | |||
| Noisy banging boiler what is the cause? | UK diy | |||
| Seal? Brass screw fitting to cast iron boiler | UK diy | |||
Threaded Mode
