 |
|
| Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work. |
|
|
LinkBack | Thread Tools | Display Modes |
|
#1
|
|||
|
|||
U joint problem
Hey,
Started putting a new u joint into that yoke and shaft and ran into a proplem. I got one "cup" in but when I tried to put the opposite cup in it wont go on straight and I have a terrible time. I am afraid this might mean the hole is out of round or something but not sure. Is there a way to get this in? What is the best way to install a u joint? |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Help with Joint Gluing Problem | Woodworking | |||
| Widespread problem with HP Omnibook XE3-GFs? | Electronics Repair | |||
| Problem with room getting too hot from facing the south (even in late October) | Home Repair | |||
| Water Pump / Pressure Tank Problem !!!!!! | Home Ownership | |||
| Problem with retrace lines on EIZO F55S... | Electronics Repair | |||
Threaded Mode
