Thread
:
U joint problem
View Single Post
#
5
Gary Brady
Posts: n/a
wrote:
Hey,
Started putting a new u joint into that yoke and shaft and ran into a
proplem. I got one "cup" in but when I tried to put the opposite cup in
it wont go on straight and I have a terrible time. I am afraid this
might mean the hole is out of round or something but not sure. Is there
a way to get this in?
What is the best way to install a u joint?
You can find the out-of-roundness by inserting the inside jaws of a dial
cailper and the rotating it. The needle will show how much deviation
you have. Use a die grinder and cartridge roll to true it up.
Gary Brady
Austin, TX
Reply With Quote