Kenmore washer acting strange
 

I have a Kenmore belt drive washer that is acting strange. I will load
the clothes, start it up and after a few minutes the clothes wil
migrate to one side of the tub causing the washer to become
unbalanced. My imbalance switch is not working properly because as the
tub contacts the switch it wil momentarily cut off but then the washer
will cut right back on again. This will go on until I stop the washer,
untangle the clothes from the agitator and redistribute the load only
for the same scenario to repeat itself. I know that the imbalance
switch is supposed to cut off the machine and buzz and not start back
up until the problem is rectified so the switch is bad, but I don't
think that is causing the washer to make the clothes to move to one
side and entangle themselves with the agitator. So if anyone out there
can help me that would be great. If this is any help the washer is
about 12 or 13 years old, give or take.

Richard

wrote in message
...
I have a Kenmore belt drive washer that is acting strange. I will load
the clothes, start it up and after a few minutes the clothes wil
migrate to one side of the tub causing the washer to become
unbalanced. My imbalance switch is not working properly because as the
tub contacts the switch it wil momentarily cut off but then the washer
will cut right back on again. This will go on until I stop the washer,
untangle the clothes from the agitator and redistribute the load only
for the same scenario to repeat itself. I know that the imbalance
switch is supposed to cut off the machine and buzz and not start back
up until the problem is rectified so the switch is bad, but I don't
think that is causing the washer to make the clothes to move to one
side and entangle themselves with the agitator. So if anyone out there
can help me that would be great. If this is any help the washer is
about 12 or 13 years old, give or take.

Richard

Add another ten years, give or take. Kenmore went to direct drive in about
1983. Kind of sounds like the agitator is not going back and forth but
turning one direction, only. A low water level might cause similar problem.

wrote in message . ..
I have a Kenmore belt drive washer that is acting strange. I will load
the clothes, start it up and after a few minutes the clothes wil
migrate to one side of the tub causing the washer to become
unbalanced. My imbalance switch is not working properly because as the
tub contacts the switch it wil momentarily cut off but then the washer
will cut right back on again. This will go on until I stop the washer,
untangle the clothes from the agitator and redistribute the load only
for the same scenario to repeat itself. I know that the imbalance
switch is supposed to cut off the machine and buzz and not start back
up until the problem is rectified so the switch is bad, but I don't
think that is causing the washer to make the clothes to move to one
side and entangle themselves with the agitator. So if anyone out there
can help me that would be great. If this is any help the washer is
about 12 or 13 years old, give or take.

Richard

Hi,

Model#? Kenmore is made by a few different companies.

but I don't
think that is causing the washer to make the clothes to move to one
side and entangle themselves with the agitator.

Too low of water level
Agitating in one direction only
Spinning while agitating
Too many clothes for the water level
The water is draining out while agitating

Above are some trouble makers for clumping the clothes together.

jeff.
Appliance Repair Aid
http://www.applianceaid.com/