Drilling big hole in ceramic tile
Hello all,
I need to re-route a dryer vent in the laundry room. I am going through the floor, and out the band joist. Anyways, there is a 12x12 tile floor in the way. I would like to be able drill right through it if possible. Of course, the alternative is breaking out the one tile, then just cutting through the sub-floor. Any suggestions ?? Thanks for your time. |
Drilling big hole in ceramic tile
Jack wrote:Hello all,
I need to re-route a dryer vent in the laundry room. I am going through the floor, and out the band joist. Anyways, there is a 12x12 tile floor in the way. I would like to be able drill right through it if possible. Of course, the alternative is breaking out the one tile, then just cutting through the sub-floor. Any suggestions ?? Thanks for your time. Get a glass/tile bit in your drill motor, and one to spare, and have at it. You'll have to drill a # of holes, then pop out the waste and clean up the edges. Have fun! Tom Work at your leisure! |
Drilling big hole in ceramic tile
Jack
Is your question how to drill through the tile ? If so...try using a 1/4 inch masonary drill bit and drill a lot of small holes in a circle...then tap the tile out with a hammer. If it's in a place where you can see it get some trim to put around the vent hose. Bob "Jack" wrote: Hello all, I need to re-route a dryer vent in the laundry room. I am going through the floor, and out the band joist. Anyways, there is a 12x12 tile floor in the way. I would like to be able drill right through it if possible. Of course, the alternative is breaking out the one tile, then just cutting through the sub-floor. Any suggestions ?? Thanks for your time. -- -------------------- http://NewsReader.Com/ -------------------- Usenet Newsgroup Service $9.95/Month 30GB |
Drilling big hole in ceramic tile
a rotozip with a tile bit will cut a nice circle in a tile.
randy "Jack" wrote in message news:ajfCc.6395$rf7.4942@lakeread02... Hello all, I need to re-route a dryer vent in the laundry room. I am going through the floor, and out the band joist. Anyways, there is a 12x12 tile floor in the way. I would like to be able drill right through it if possible. Of course, the alternative is breaking out the one tile, then just cutting through the sub-floor. Any suggestions ?? Thanks for your time. |
All times are GMT +1. The time now is 05:09 PM. |
Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004 - 2014 DIYbanter