Miter Cuts on Oak faced plywood?
 

I am going to build a bookcase out of oak faced plywood, with oak trim.

The only place where the plywood edge will be exposed is where the sides
meet the top.
Is it possible to miter them at 45, so as to have no edge showing? Will the
veneer survive a 45 cut?

I suppose the alternatives are veneering the exposed edge, or using solid
oak for the top.
I have never veneered before; how foolproof is it?

Miter Cuts on Oak faced plywood?
 

"Wade Lippman" wrote in message
...
I am going to build a bookcase out of oak faced plywood, with oak trim.

The only place where the plywood edge will be exposed is where the sides
meet the top.
Is it possible to miter them at 45, so as to have no edge showing? Will
the
veneer survive a 45 cut?

I suppose the alternatives are veneering the exposed edge, or using solid
oak for the top.
I have never veneered before; how foolproof is it?



I just recently did the same thing and the 45 worked for me. I did mess up
the first 45 because I used a rough blade and it chipped. Made a second cut
with a plywood blade and it went smooth, then I cut to size my lengths. the
45's look good and looks like real oak :)

As for the veneering.....I never tried it, but I could stay at a Holiday Inn
Express and then give it a try :)

Miter Cuts on Oak faced plywood?
 

On Thu, 28 Aug 2003 15:34:21 GMT, "Wade Lippman"
wrote:

I am going to build a bookcase out of oak faced plywood, with oak trim.

The only place where the plywood edge will be exposed is where the sides
meet the top.
Is it possible to miter them at 45, so as to have no edge showing? Will the
veneer survive a 45 cut?

I suppose the alternatives are veneering the exposed edge, or using solid
oak for the top.
I have never veneered before; how foolproof is it?


Try "scoring" the cut with a razor knife, on the outermost point of
the miter. Use a square to do this, as you just want to cut the
veneer.
Use a framing square to "ride" the saw's shoe against, staying just a
"hair" beyond your "scored" cut line.

Miter Cuts on Oak faced plywood?
 

Miter joints are ok, but they are difficult to perform cleanly.

It might be more normal to "edge band" the exposed plywood edges with a
glued on strip of real oak. The top can be made to overhang the carcase
sides and front this way.

--


Keep the whole world singing. . .
Dan G

(remove the 7)




Wade Lippman wrote:
I am going to build a bookcase out of oak faced plywood, with oak
trim.

The only place where the plywood edge will be exposed is where the
sides meet the top.
Is it possible to miter them at 45, so as to have no edge showing?
Will the veneer survive a 45 cut?

I suppose the alternatives are veneering the exposed edge, or using
solid oak for the top.
I have never veneered before; how foolproof is it?