Painting the Transition Between Drywall and Plaster
 

After extensive plaster ceiling repairs, where my ceiling meets the
walls, there is a transition between plaster (ceilings) and drywall
(walls) about one foot down on the walls. After painting with flat
latex paint, the painted plaster on the upper walls appears lighter
and shinier than the painted drywall (lower down on the walls). This
is especially so right where the wall meets the ceiling, where I've
used a brush (rather than a roller) to cut-in. (Of course, the
plaster is much smoother than the drywall.)

Is there anything I could do to minimize the transition between the
plaster and the drywall in terms of painted finish/texture? Someone
suggested using a thicker nap roller on the plaster to create some
texture that would match the "orange peel" appearance of the drywall.

Any advice?

Painting the Transition Between Drywall and Plaster
 

wrote:
After extensive plaster ceiling repairs, where my ceiling meets the
walls, there is a transition between plaster (ceilings) and drywall
(walls) about one foot down on the walls. After painting with flat
latex paint, the painted plaster on the upper walls appears lighter
and shinier than the painted drywall (lower down on the walls). This
is especially so right where the wall meets the ceiling, where I've
used a brush (rather than a roller) to cut-in. (Of course, the
plaster is much smoother than the drywall.)

Is there anything I could do to minimize the transition between the
plaster and the drywall in terms of painted finish/texture? Someone
suggested using a thicker nap roller on the plaster to create some
texture that would match the "orange peel" appearance of the drywall.

Any advice?

Try rolling on a primer/filler like Sheetrock First Coat, followed by a
good primer/sealer, and then paint.

http://www.amazon.com/Ready-Mix-Shee.../dp/B000BZYXRK

Painting the Transition Between Drywall and Plaster
 

Painting the Transition Between Drywall and Plaster
 

Norminn wrote:

wrote:

After extensive plaster ceiling repairs, where my ceiling meets the
walls, there is a transition between plaster (ceilings) and drywall
(walls) about one foot down on the walls. After painting with flat
latex paint, the painted plaster on the upper walls appears lighter
and shinier than the painted drywall (lower down on the walls). This
is especially so right where the wall meets the ceiling, where I've
used a brush (rather than a roller) to cut-in. (Of course, the
plaster is much smoother than the drywall.)

Is there anything I could do to minimize the transition between the
plaster and the drywall in terms of painted finish/texture? Someone
suggested using a thicker nap roller on the plaster to create some
texture that would match the "orange peel" appearance of the drywall.

Any advice?


The plaster is new? Primed? The drywall is old, previously painted?

And.........did the plaster cure for at least a month?

Painting the Transition Between Drywall and Plaster
 

On Sep 16, 12:19*pm, Norminn wrote:
Norminn wrote:
wrote:

After extensive plaster ceiling repairs, where my ceiling meets the
walls, there is a transition between plaster (ceilings) and drywall
(walls) about one foot down on the walls. *After painting with flat
latex paint, the painted plaster on the upper walls appears lighter
and shinier than the painted drywall (lower down on the walls). *This
is especially so right where the wall meets the ceiling, where I've
used a brush (rather than a roller) to cut-in. *(Of course, the
plaster is much smoother than the drywall.)

Is there anything I could do to minimize the transition between the
plaster and the drywall in terms of painted finish/texture? *Someone
suggested using a thicker nap roller on the plaster to create some
texture that would match the "orange peel" appearance of the drywall.

Any advice?

The plaster is new? *Primed? *The drywall is old, previously painted?

And.........did the plaster cure for at least a month?

The room is totally painted, so I really can't go back and repaint the
whole room with the Sheetrock product. I am willing, though, to go
over the area where the ceiling meets the wall. Should I just keep
recoating until the tones match? What about brushstrokes, as compared
to the texture a roller leaves?

Painting the Transition Between Drywall and Plaster
 

On Sep 16, 4:01*pm, wrote:
On Sep 16, 12:19*pm, Norminn wrote:



Norminn wrote:
wrote:

After extensive plaster ceiling repairs, where my ceiling meets the
walls, there is a transition between plaster (ceilings) and drywall
(walls) about one foot down on the walls. *After painting with flat
latex paint, the painted plaster on the upper walls appears lighter
and shinier than the painted drywall (lower down on the walls). *This
is especially so right where the wall meets the ceiling, where I've
used a brush (rather than a roller) to cut-in. *(Of course, the
plaster is much smoother than the drywall.)

Is there anything I could do to minimize the transition between the
plaster and the drywall in terms of painted finish/texture? *Someone
suggested using a thicker nap roller on the plaster to create some
texture that would match the "orange peel" appearance of the drywall..

Any advice?

The plaster is new? *Primed? *The drywall is old, previously painted?

And.........did the plaster cure for at least a month?

The room is totally painted, so I really can't go back and repaint the
whole room with the Sheetrock product. *I am willing, though, to go
over the area where the ceiling meets the wall. *Should I just keep
recoating until the tones match? *What about brushstrokes, as compared
to the texture a roller leaves?

You can't paint one foot down on a wall and expect it to match. Even
if you didn't have the plaster/drywall texture difference - it always
shows up. Using a coarser nap roller cover and painting the smoother
area, then letting it dry and painting the whole wall with the
original roller cover is one sequence I use to match textures. Using
a coarser roller cover for the whole thing is fine if you like
slightly textured walls more than smoother ones.

R

Painting the Transition Between Drywall and Plaster
 

On Tue, 16 Sep 2008 08:33:20 -0700, gobofraggle wrote:

After extensive plaster ceiling repairs, where my ceiling meets the
walls, there is a transition between plaster (ceilings) and drywall
(walls) about one foot down on the walls. After painting with flat
latex paint, the painted plaster on the upper walls appears lighter and
shinier than the painted drywall (lower down on the walls). This is
especially so right where the wall meets the ceiling, where I've used a
brush (rather than a roller) to cut-in. (Of course, the plaster is much
smoother than the drywall.)

Is there anything I could do to minimize the transition between the
plaster and the drywall in terms of painted finish/texture? Someone
suggested using a thicker nap roller on the plaster to create some
texture that would match the "orange peel" appearance of the drywall.

Any advice?

If, and that could be a big IF, I understand your question:

Talk to a decorator, getting a match between plaster and drywall will be
hard to do. So, don't try. Use another approach, such as a decorative
wall-paper strip (with boarder) about 12" or 24" from the ceiling down on
each wall. (or how ever far down the wall the problem is.)

Warning, if you don't know what you are doing with matching wall paper
colors, window treatment, carpets, color schemes, and color transitions
room-to-room, you can get into a lot of ugly real fast.

Painting the Transition Between Drywall and Plaster
 

Using drywall primer on both surfaces would have netted an even looking
finish.

s


wrote in message
...
After extensive plaster ceiling repairs, where my ceiling meets the
walls, there is a transition between plaster (ceilings) and drywall
(walls) about one foot down on the walls. After painting with flat
latex paint, the painted plaster on the upper walls appears lighter
and shinier than the painted drywall (lower down on the walls). This
is especially so right where the wall meets the ceiling, where I've
used a brush (rather than a roller) to cut-in. (Of course, the
plaster is much smoother than the drywall.)

Is there anything I could do to minimize the transition between the
plaster and the drywall in terms of painted finish/texture? Someone
suggested using a thicker nap roller on the plaster to create some
texture that would match the "orange peel" appearance of the drywall.

Any advice?

Painting the Transition Between Drywall and Plaster