DIYbanter

DIYbanter (https://www.diybanter.com/)
-   Home Repair (https://www.diybanter.com/home-repair/)
-   -   Snow (https://www.diybanter.com/home-repair/232260-snow.html)

Frank[_5_] February 1st 08 04:54 PM

Snow
 
Just had our first 15" snow out here in years. Used my trusty M Wards 30 yr
old 2 stage to clear 100' drive .All was OK except machine kept clogging . I
tried white grease, silicone, soap in the past. Not to good. Any
suggestions?
Frank



Mike Dobony February 1st 08 05:04 PM

Snow
 

"Frank" wrote in message
. ..
Just had our first 15" snow out here in years. Used my trusty M Wards 30

yr
old 2 stage to clear 100' drive .All was OK except machine kept clogging .

I
tried white grease, silicone, soap in the past. Not to good. Any
suggestions?
Frank



a good wax job and plow in first gear, stopping often to let it clear out.



EXT February 1st 08 05:34 PM

Snow
 

"Mike Dobony" wrote in message
...

"Frank" wrote in message
. ..
Just had our first 15" snow out here in years. Used my trusty M Wards 30

yr
old 2 stage to clear 100' drive .All was OK except machine kept clogging
.

I
tried white grease, silicone, soap in the past. Not to good. Any
suggestions?
Frank



a good wax job and plow in first gear, stopping often to let it clear out.


Yes, all of the above, you may also have some rust that is causing drag.
Sometimes it is not the fault of the snow blower, sometimes you have heavy
wet snow at exactly the freezing point, once the snow blower starts moving
it around at high speeds the snow starts to stiffen up and semi freeze like
a slushie. When this happens, all you can do is try not to load up the
blower by taking smaller slices of the snow, and be prepared for lots of
cleaning out.

It is sort of like the first grass mowing of the spring season, where the
grass is long, wet, juicy and clogs the mower every few feet. Don't you
wish!



ransley February 1st 08 05:58 PM

Snow
 
On Feb 1, 10:54*am, "Frank" wrote:
Just had our first 15" snow out here in years. Used my trusty M Wards 30 yr
old 2 stage to clear 100' drive .All was OK except machine kept clogging . I
tried white grease, silicone, soap in the past. Not to good. Any
suggestions?
* * * * * * * * Frank


Call around for a product called Slip Plate common at farm stores, its
a teflon type spray that really works even on your mower to keep grass
from sticking, and your snow shovel.

Jim Elbrecht February 1st 08 08:52 PM

Snow
 
"Frank" wrote:

Just had our first 15" snow out here in years. Used my trusty M Wards 30 yr
old 2 stage to clear 100' drive .All was OK except machine kept clogging . I
tried white grease, silicone, soap in the past. Not to good. Any
suggestions?


I bought a 32 yr old Bolens this summer. There was a little rust in
the chute so I sandblasted it out with a $10 HF gravity feed blaster
and some play sand. Then I mixed up some fiberglass & laid a
little in the chute. Followed up with a couple coats until all the
texture in the cloth was gone.

We haven't had enough snow to really abuse it this winter, but I
managed a few hours of blowing, and the fiberglass is secure & doesn't
hold any snow.

Then I made the impeller improvement that Clarence sells for $30-
Here's the address and some reviews;
http://www.abbysguide.com/ope/reviews/355-0-1.html
The video is here-
http://www.youtube.com/watch?v=qOmS6ZaCPuE
and a still, here;
http://www.opeonthenet.com/phpBB2/viewtopic.php?t=5673
[there's a new chute here, too-- but that's a 4horse tossing snow
higher than the rooftops]

$30 seems like a fair price, but I had all the parts lying within
reach and wanted to recycle the rubbers off an old Toro single stage
that just got a new pair.

This 7hp, 26inch blower now throws soupy slush all of 10 feet, and dry
powder shoots out like the commercials for new Toros.

The only downside I can see with the impeller kit is that it probably
strains the belt a little bit more.

Also, the way I put mine in, until they wear down a bit, they keep the
impeller from turning in reverse to remove a stick or stone. I
picked up a split 1x3 a foot long which made it to the impeller & I
needed to use a six foot bar to relieve the tension enough to pull it
back out.

Jim

Jim Elbrecht February 1st 08 11:01 PM

Snow
 
"Frank" wrote:

Just had our first 15" snow out here in years. Used my trusty M Wards 30 yr
old 2 stage to clear 100' drive .All was OK except machine kept clogging . I
tried white grease, silicone, soap in the past. Not to good. Any
suggestions?


Just remembered- Before doing *anything* else, be sure your belt is
in good condition and that it is properly adjusted.

It might just be a replaceable spring and idler pulley on that one-
That was common on Bolens, Ariens & some others of that vintage.

Jim

BobR February 2nd 08 12:16 AM

Snow
 
On Feb 1, 12:05*pm, "Blattus Slafaly £ ¥ 0/00 :)"
wrote:
Frank wrote:
Just had our first 15" snow out here in years. Used my trusty M Wards 30 yr
old 2 stage to clear 100' drive .All was OK except machine kept clogging . I
tried white grease, silicone, soap in the past. Not to good. Any
suggestions?
* * * * * * * * Frank


Open the throttle wide open to fling the snow out of it.

--
Blattus Slafaly *? 3 * * :) *7/8


Don't know about you but I am ready for some of that GLOBAL WARMING.
I have had enough winter.


boden February 2nd 08 12:43 AM

Snow
 
BobR wrote:
On Feb 1, 12:05 pm, "Blattus Slafaly £ ¥ 0/00 :)"
wrote:

Frank wrote:

Just had our first 15" snow out here in years. Used my trusty M Wards 30 yr
old 2 stage to clear 100' drive .All was OK except machine kept clogging . I
tried white grease, silicone, soap in the past. Not to good. Any
suggestions?
Frank


Open the throttle wide open to fling the snow out of it.

--
Blattus Slafaly ? 3 :) 7/8



Don't know about you but I am ready for some of that GLOBAL WARMING.
I have had enough winter.

Speak to Al Gore. He thinks he knows where it is. I Have so much snow
outside that I'm convinced that Gore is either a purveyor of lies or a
Washington politician.

Boden

S. Barker February 2nd 08 12:50 AM

Snow
 
Ya, go slower.

s


"Frank" wrote in message
. ..
Just had our first 15" snow out here in years. Used my trusty M Wards 30
yr old 2 stage to clear 100' drive .All was OK except machine kept
clogging . I tried white grease, silicone, soap in the past. Not to good.
Any suggestions?
Frank




Doug Brown February 2nd 08 04:17 AM

Snow
 
Well I don't have a lot of snow but in my part of Canukistan the last week
has really been brutal. Wiithout expagerating my deep freeze has been
warmer that outside temps and when the windchill if factored in, Mars
doesn't look too bad!

Boden wrote:
BobR wrote:
On Feb 1, 12:05 pm, "Blattus Slafaly £ ¥ 0/00 :)"
wrote:

Frank wrote:

Just had our first 15" snow out here in years. Used my trusty M
Wards 30 yr old 2 stage to clear 100' drive .All was OK except
machine kept clogging . I tried white grease, silicone, soap in
the past. Not to good. Any suggestions?
Frank

Open the throttle wide open to fling the snow out of it.

--
Blattus Slafaly ? 3 :) 7/8



Don't know about you but I am ready for some of that GLOBAL WARMING.
I have had enough winter.

Speak to Al Gore. He thinks he knows where it is. I Have so much
snow outside that I'm convinced that Gore is either a purveyor of
lies or a Washington politician.

Boden





All times are GMT +1. The time now is 05:22 PM.

Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004 - 2014 DIYbanter