Just had my roof torn off and new roof installed. They had to cut off
the Douglas Fir rafter tails and one workman got sloppy and cut one at
an odd angle, taking off too much of the tail. It's a 2x8 end rafter. I
pointed this out to the project manager yesterday and he said they'd fix
it. He sent the crew chief back with another guy and he scarfed on a
piece of redwood to the fir with a nail gun and epoxy and he sealed the
seams with some kind of white caulk. The cut is straight down now like
it should be now but the redwood was new 2x stock and fully 1/4 inch
narrower than the rafter it's scarfed onto. It looks cheezy. I didn't
say anything because I already had them fix a bunch of other little
things and I think they gave me a good deal and overall did a good job,
and I didn't want to prevail upon them. But I want to fix it right.

Removing the piece he nailed and glued on seems far too difficult, so I
want to glue on a couple of pieces of thin stock to the sides of his
redwood 2x8. These will be slightly oversize, and I will sand down the
extra flush to the size of the rafter. The area of the glue joints will
be around 3 square inches each. Those rafter tails will be getting a lot
of exposure to the rain and sun. I plan to prime and paint, after the
fix job, of course. What glues might I use successfully on this? Should
I also apply a caulk? Thanks!

Dan