Home |
Search |
Today's Posts |
|
#1
![]() |
|||
|
|||
![]()
What resistor circuit is needed for a low current trafic alert device
which can be plugged into the courtesy light? The traffic alert normally runs on 3 AAA batteries, but a terminal has corroded off... }:-( Happy with a soldering iron and vero board cheers Richard |
#2
![]() |
|||
|
|||
![]()
Attach a 1 kohm resistor between 12 volts and the device you want to power.
Measure the voltage at the device. If the voltage is below, decrease the resistor until you obtain 4.5 volts. Now add a 4.5 volt zener diode because the vehicle voltage can vary from 7 up to 15 volts. Harold wrote in message oups.com... What resistor circuit is needed for a low current trafic alert device which can be plugged into the courtesy light? The traffic alert normally runs on 3 AAA batteries, but a terminal has corroded off... }:-( Happy with a soldering iron and vero board cheers Richard |
#3
![]() |
|||
|
|||
![]()
Thanks for that and other info have helped cheers
|
#4
![]() |
|||
|
|||
![]()
Thanks for that and other info have helped cheers
|
#5
![]() |
|||
|
|||
![]()
put a 1W 7volt zener in series, no resistor needed....
|
#6
![]() |
|||
|
|||
![]()
On Tue, 08 Nov 2005 01:36:31 GMT, "lee" wrote:
put a 1W 7volt zener in series, no resistor needed.... --- Really? First of all, you can't get a 7V Zener, and, what will happen if the input voltage goes up to 13.8V or you wind up with a 60V transient on the line? -- John Fields Professional Circuit Designer |
#7
![]() |
|||
|
|||
![]()
On Tue, 01 Nov 2005 13:45:05 -0800, richard.dykes wrote:
What resistor circuit is needed for a low current trafic alert device which can be plugged into the courtesy light? The traffic alert normally runs on 3 AAA batteries, but a terminal has corroded off... }:-( Happy with a soldering iron and vero board You shouldn't need much: http://www.radioshack.com/product/in...&tab=techSpecs Or, you could use a hash choke, a transzorb, and a regulator to do pretty much the same thing. ;-) Cheers! Rich |
#8
![]() |
|||
|
|||
![]()
On Tue, 08 Nov 2005 18:47:55 GMT, Rich Grise
wrote: Or, you could use a hash choke, a transzorb, and a regulator to do pretty much the same thing. ;-) --- Hash choke... mmmmmm... -- John Fields Professional Circuit Designer |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
Semi OT Electrical Question | Woodworking | |||
15A Circuit Breaker on a Power Tap | Electronics | |||
sequence of tripping CB | UK diy | |||
Astron VS-35M power supply broken | Electronics Repair | |||
Phase converter balancing | Metalworking |