Home |
Search |
Today's Posts |
|
Electronics Repair (sci.electronics.repair) Discussion of repairing electronic equipment. Topics include requests for assistance, where to obtain servicing information and parts, techniques for diagnosis and repair, and annecdotes about success, failures and problems. |
|
LinkBack | Thread Tools | Display Modes |
#1
|
|||
|
|||
Toshiba 61H70 61HX70 Rear Projection CRTs won't turn on
Hello. Tried doing a lot of troubleshooting on my 61H70. Have normal
Sound, but no picture at all. CRTs don't fire. Probed various points. Have 220v coming into the CRT Drive boards. Have at least 170v at pin K of each of the R,G,B board's V901, V902, V903. Here's where I'm suspecting the problem. The nominal voltages shown on my schematic (if I'm reading the RED voltages next to the pins correctly) shows that R , G, AND B lines of the 7 pin connector of the CRT -D/G board should be at around 3.0 volts. I'm reading 1.5V. Traced these lines back to the SIGNAL/CONV board's Q510 VIDEO CHROMA IC (56-pin, ta1316n or ta1276an) and pins 41, 42, 43 (B, G, R respectively) should all read around 2.5 volts. I'm reading 0.7 volts. Did a couple of readings on other pins on this ic and seems to read normally (eg: pin 30 reads 4.5v as it should). Question: is this Q510 ic typically the cause of this type of problems, or could the other parts around this ic cause it? I would be grateful if any of you technicians (or handymen) who have worked on 61H70, 61HX70, 50HX70 and similar models would share your experiences. Thank you! Steven L. |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Toshiba Projection TV Convergence Problem | Electronics Repair | |||
ICs for Sale - Specials, obsolete and Memory | Electronics Repair | |||
Toshiba Projection TV Help. | Electronics Repair | |||
Toshiba Rear Projection TV convergence and power problem | Electronics Repair | |||
Question on Wide Screen Rear Projection | Electronics Repair |