 |
|
| Electronics Repair (sci.electronics.repair) Discussion of repairing electronic equipment. Topics include requests for assistance, where to obtain servicing information and parts, techniques for diagnosis and repair, and annecdotes about success, failures and problems. |
| Reply |
|
|
LinkBack | Thread Tools | Display Modes |
|
#1
|
|||
|
|||
Samsung S51A chassis TV fault
This set switches on briefly (less than 1 sec) with EHT, then off again and
rapidly flashes red LED on front till switched of at mains. Replaced the video processor tda 8844, wich was 12 ohm to ground on pin 47.also replaced vertical ic tda7845 wich had a big hole in it! The set still has same symptom as before. Pin 50 on the tda 8844 is over-voltage protection and reads about 2.1 VDC when the fault is present but as i am without a diagam i dont know if this pin will go hi or low with overvoltage. HELP! |
| Reply |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Samsung Microwave & GE Microwave oven | Electronics Repair | |||
| Samsung TVp5050f chassis scv11A left side of screen blank ! | Electronics Repair | |||
| Tech Review: Victor's (8liners/Genao) Replacement Arcade RGB Monitor Chassis (LONG) | Electronics Repair | |||
| Samsung tv set chassis kct52b | Electronics Repair | |||
| Need Sony Monitor schematic CDM-5021PT | Electronics Repair | |||
Linear Mode
