Hi!
R.C.A. Chassis ATC113CA1 , need to know how to correct the width on this
set, it is way to wide and if I adjust the horazontal size it puts a bend in
the picture.
Thank you
Vince

There is a little board mounted just by the HOT
this controls pincushioning etc you will have to trouble
shoot the parts on that board and possibly on the main board.
What is the Model Number ?


"Vince" wrote in message
...
Hi!
R.C.A. Chassis ATC113CA1 , need to know how to correct the width on this
set, it is way to wide and if I adjust the horazontal size it puts a bend
in the picture.
Thank you
Vince

Also, the whole board is available from RCA as a part. However, if you are
going to troubleshoot it consider the small caps near the small ic mounted
on that pcb. They have been causing a bit of a problem.
"kip" wrote in message
.. .
There is a little board mounted just by the HOT
this controls pincushioning etc you will have to trouble
shoot the parts on that board and possibly on the main board.
What is the Model Number ?


"Vince" wrote in message
...
Hi!
R.C.A. Chassis ATC113CA1 , need to know how to correct the width on this
set, it is way to wide and if I adjust the horazontal size it puts a bend
in the picture.
Thank you
Vince

---------------------------------------------------------------
Text pasted from WinSTIPS 2.0
http://www.ServiceSoftware.com
---------------------------------------------------------------

RCA ATC113

Width Excessive

ATC113BB1

Replaced Cl12 Cap. 257148, Cl06 Cap. 227068, Cl21 Cap. 257784, And Dl08
Diode 243636.

---------------------------------------------------------------

RCA ATC113

Width Excessive



Found Defective Cl85 On Pincushion Board. 6.8mfd/50v Cap Part No. 238292
Read High Esr Out Of Circuit.


---------------------------------------------------------------



--
==========================
Jeff Stielau
Shoreline Electronics Repair
344 East Main Street
Clinton,CT 06413
860-399-1861
860-664-3535 (fax)

========================

"Vince" wrote in message
...
Hi!
R.C.A. Chassis ATC113CA1 , need to know how to correct the width on this
set, it is way to wide and if I adjust the horazontal size it puts a bend
in the picture.
Thank you
Vince