 |
|
| Electronics Repair (sci.electronics.repair) Discussion of repairing electronic equipment. Topics include requests for assistance, where to obtain servicing information and parts, techniques for diagnosis and repair, and annecdotes about success, failures and problems. |
|
|
LinkBack | Thread Tools | Display Modes |
|
#1
|
|||
|
|||
Pots for consumer gear
I have a guitar amplifier under repair, needing several pots that are
printed circuit mounted -- 15 mm diameter with 3/8 bushing and toothed shaft. Are there any good sources of replacement parts for this sort of thing? Clearly, the exact fit is important. Neither Digi-Key nor Mouser have these. Going to the manufacturer for these parts is hopefully a last resort, as I would expect to pay a lot. |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Gear fabrication advise needed | Metalworking | |||
| one-off gear cutting info needed. | Metalworking | |||
| Gear cutting...am I crazy? (long) | Metalworking | |||
| Help a newbie out? | Metalworking | |||
Threaded Mode
