Electronics Repair (sci.electronics.repair) Discussion of repairing electronic equipment. Topics include requests for assistance, where to obtain servicing information and parts, techniques for diagnosis and repair, and annecdotes about success, failures and problems.

 
 
LinkBack Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
  #5   Report Post  
dkuhajda
 
Posts: n/a
Default

22uf and 100uf in the smps circuit go bad. These take out the regulator,
which in turn takes out the transistor, and the 0.18ohm resistor, plus a
couple of other parts.

After that you need to verify the standby voltages to the system control,
the 9v regulator is another common failure item. Just do standard SMPS
troubleshooting techniques following the schematic.

David



 
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Zenith Model SY3288DT 32" TV WILL NOT TURN ON Ron Novini Electronics Repair 1 September 17th 03 06:05 AM
Zenith Floor Model Repair Info Please Dan Gett Electronics Repair 0 July 15th 03 03:42 AM


All times are GMT +1. The time now is 11:59 PM.

Powered by vBulletin® Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright ©2004-2025 DIYbanter.
The comments are property of their posters.
 

About Us

"It's about DIY & home improvement"