Home |
Search |
Today's Posts |
|
Electronics Repair (sci.electronics.repair) Discussion of repairing electronic equipment. Topics include requests for assistance, where to obtain servicing information and parts, techniques for diagnosis and repair, and annecdotes about success, failures and problems. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
#1
|
|||
|
|||
mitsu-vs-5020r projo no picture
we are working on a mitsu vs-5020r projo
the main power supply board is good, there is no picture, no menus, no input coming thru or audio. when input is cycled with remote and attempt to switch to ch 3 on each input in an attempt to get atleast audio, we hear a relay clicking upon switching input, but audio never comes in to verify that we atleast are on the right channel. any ideas on what board might be causing this lack of picture and audio, or what may be the prob. it appears that the guns are not heating up, but ay be excessive dust on them that didnt come off with blowing them off. also we were curious without having the schematic for this one, what is the connection on the powersupply board that says TPAG/GND, looks like a degauss circuit hook up. could that be a remanant for another set that is not being used or is there something that needs to be hooked there that could be causing this problem? wolf |
#2
|
|||
|
|||
mitsu-vs-5020r projo no picture
You will need to check virtually every polarized electrolytic capacitor
(every one made by Nichicon or Rubycon at the very least) in the set for electrolyte leakage, ESR, and DC leakage. Search the newsgroup archives for Mitsubishi V10 and V11 chassis for more detailed suggestions on how to locate the bad caps. If you don't get all of the bad ones before trying to troubleshoot you will likely chase your tail. TPAG shorted to ground simply forces the relay on for testing purposes. Be cautious as vertical output problems are not uncommon and you can burn the CRTs on some sets. Leonard Caillouet "wolf" wrote in message link.net... we are working on a mitsu vs-5020r projo the main power supply board is good, there is no picture, no menus, no input coming thru or audio. when input is cycled with remote and attempt to switch to ch 3 on each input in an attempt to get atleast audio, we hear a relay clicking upon switching input, but audio never comes in to verify that we atleast are on the right channel. any ideas on what board might be causing this lack of picture and audio, or what may be the prob. it appears that the guns are not heating up, but ay be excessive dust on them that didnt come off with blowing them off. also we were curious without having the schematic for this one, what is the connection on the powersupply board that says TPAG/GND, looks like a degauss circuit hook up. could that be a remanant for another set that is not being used or is there something that needs to be hooked there that could be causing this problem? wolf |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Horizontal width of picture, RCA console | Electronics | |||
pioneer sp-k5075 projo tv no picture on coax inputs | Electronics Repair | |||
HELP needed. Was CRT arcing now Fuzzy Picture | Electronics Repair |