Electronics Repair (sci.electronics.repair) Discussion of repairing electronic equipment. Topics include requests for assistance, where to obtain servicing information and parts, techniques for diagnosis and repair, and annecdotes about success, failures and problems.

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
  #1   Report Post  
henry
 
Posts: n/a
Default gateway2000 EV900 died and buzzes

specifically EV900-7000595
The last day it was working it was randomly clicking a lot and the
screen would jump when it did it. Now it wont power up but clicks
(buzzes) quickly making a racheting sound if I try.

As you can tell, I haven't pulled it apart yet or know the correct CRT
jargon but I'm good with a multimeter and soldering iron so I'm not
afraid to dig in.
People mention the fbt a lot with this model as a common failure spot.

Somebody please tell me what to check.
Thanks
Henry
  #2   Report Post  
glasnostJDC
 
Posts: n/a
Default gateway2000 EV900 died and buzzes

What is the chassis number? Or FCC ID nunber? On a Gateway EV700 with the LG
CA-65 Chassis it would turn on for 20 minutes then turn itself off, and then
keep doing it after 5 to 10 minutes (I may be wrong with the times but it
was awhile ago I did this monitor). I traced it to a 15 volt line in the
SMPS that was going from 0 to 10 volts. I resoulded pin 16 off of the main
transformer and that fixed the issue (check the transistors too, sometimes
they go bad), I'd go for all the souder joints as well in the SMPS. Make
sure to discharge the filter caps. Hope some of this helps you out. I'm not
sure if this information would carrie into the EV900 LG Chassis, but it may
be some helpful information.

"henry" wrote in message
om...
specifically EV900-7000595
The last day it was working it was randomly clicking a lot and the
screen would jump when it did it. Now it wont power up but clicks
(buzzes) quickly making a racheting sound if I try.

As you can tell, I haven't pulled it apart yet or know the correct CRT
jargon but I'm good with a multimeter and soldering iron so I'm not
afraid to dig in.
People mention the fbt a lot with this model as a common failure spot.

Somebody please tell me what to check.
Thanks
Henry




Reply
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On



All times are GMT +1. The time now is 08:18 PM.

Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 DIYbanter.
The comments are property of their posters.
 

About Us

"It's about DIY & home improvement"