Home |
Search |
Today's Posts |
|
Electronics Repair (sci.electronics.repair) Discussion of repairing electronic equipment. Topics include requests for assistance, where to obtain servicing information and parts, techniques for diagnosis and repair, and annecdotes about success, failures and problems. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
#1
|
|||
|
|||
JVC VCR HR-S9500U, HR-S4700U, HR-S4500U: AFTER 3 SECS. POWER SHUTS DOWN
I'm trying to service a JVC VCR Model #HR-S9500U that keeps shutting down
whenever you push the power button on with or without a tape, it does not matter. The display will flash to "AUTO" after 3 seconds of pushing the power button on. I have made sure that the parental control is not enabled, I have verified that all the sensors are working properly, I have verified that the power supply is working properly and have checked all electrolytic caps in the supply, I have also verified that both belts are in good condition and the mode switch is good too. The VCR will accept a tape and once it is in position to play, the VCR shuts down. I have a service manual for this VCR and so far haven't been able to find the problem. This particular model is also similar to a HR-S4500U and a HR-S4700U VCR according to the service manual that covers all three models. I have seen previous posts in this NG with people experiencing the same symptoms that I am experiencing and have also seen this problem posted in various tech forums, but so far I haven't been able to find an answer. If there is anyone here who can give me some clue as to what is wrong with this VCR, I would surely like to know!!!! Thanks for any assistance you can offer. Mac |
#2
|
|||
|
|||
JVC VCR HR-S9500U, HR-S4700U, HR-S4500U: AFTER 3 SECS. POWER SHUTS DOWN
trying to service a JVC VCR Model #HR-S9500U that keeps shutting down
whenever you push the power button on with or without a tape, it does not matter. The display will flash to "AUTO" after 3 seconds of pushing the power button on. On the HR-S9500U, sounds like the Dynamic Drum is not so dynamic. (Joke). The DD drive circuit is not initializing and moving the drum motor on power up and is probably causing the unit to shut down. Usually one of the gears on the bottom of the drum assy unit is worn. They do not sell them separately and you usually have to replace the whole drum motor assy. Don't know about the HRS4500U unless it uses that ridiculous same circuit. The HR-S4700U is a much older unit and not anything like the HR-S9500U. Hope that helps. PS...I'm not talking about drum drive circuit. The Dynamic Drum causes vertical movement of the drum motor in special effects operations. Mike W Video Services |
#3
|
|||
|
|||
JVC VCR HR-S9500U, HR-S4700U, HR-S4500U: AFTER 3 SECS. POWERSH...
Does the tape go down in ok when you insert it then wont eject ?
It may be in child lock . try holding the power button on the remote down for a few seconds |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Quality Of Tools | UK diy | |||
Generator FAQ | Metalworking | |||
RCA TV CTC169 (BG5) F35750ST Wont come out of standby - Ticking sound when Power button is pressed | Electronics Repair | |||
power flushing | UK diy |