Home |
Search |
Today's Posts |
|
Electronics Repair (sci.electronics.repair) Discussion of repairing electronic equipment. Topics include requests for assistance, where to obtain servicing information and parts, techniques for diagnosis and repair, and annecdotes about success, failures and problems. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
#1
|
|||
|
|||
Toshiba convergence problem
I have a 4 year old Toshiba X81 series RPTV that has always had a
small problem with convergence in the upper right corner of the screen. The red horiz lines on the grid curve up while the red vert lines curve out, almost as if the upper right corner of the red gun is being "pulled out" an inch or two. Is this caused by a problem in the deflection yoke. The red gun was recently replaced for another reason, but the problem was the same before and after the gun itself was replaced. The red is just fine in the other 3 corners, and the green and blue don't have the problem at all. Focus is fine in all parts of the screen. Ron |
#2
|
|||
|
|||
Toshiba convergence problem
Either it needs one of the output ICs, likely because this is the natural
stretch, or the DC offset is too much. You change the ICs first, they are most common, or you can check them with a scope with differential inputs. I think your odds are 70% or better that it is the output ICs. Do it right, clean the sink completely and put a BEAD of compound right between the screw holes, DO NOT spread the compound ! This assures less air pockets. These things are stereo power amplifiers turned ALL THE WAY UP ALL THE TIME !, they NEED to get rid of heat and thus the installation needs to be done correctly. JURB |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Hitachi 43FDX01b Looks like Digicon board problem? | Electronics Repair | |||
Sony 53XBR35 Pincushion/convergence problem | Electronics Repair | |||
Toshiba Model # CF2765K Chassis #: 9010 Vertical Problem | Electronics Repair |