CTC 169 Chassis
Have a 27" Proscan that works fine once you get it to come on, but
intermittently will not start up. When it won't start there is no 143 volts standby voltage. There is raw 150 volts, actually more like 160 volts. Haven't yet found any shorted or open components in regulator circuit. Any tips on what is the most common component failure with these symptoms. Thanks. |
CTC 169 Chassis
Replace the 15 Volt rectifier diode and check the electrolytic caps in the
regulator circuit. "JAG" wrote in message ... Have a 27" Proscan that works fine once you get it to come on, but intermittently will not start up. When it won't start there is no 143 volts standby voltage. There is raw 150 volts, actually more like 160 volts. Haven't yet found any shorted or open components in regulator circuit. Any tips on what is the most common component failure with these symptoms. Thanks. |
CTC 169 Chassis
Been out ot touch since email has been down, but think I have found trouble.
Turned out to be 2.2mfd cap in regulator circuit, but thanks anyway for response. Your suggestion would have been right on. Thanks. "AJ" wrote in message . .. Replace the 15 Volt rectifier diode and check the electrolytic caps in the regulator circuit. "JAG" wrote in message ... Have a 27" Proscan that works fine once you get it to come on, but intermittently will not start up. When it won't start there is no 143 volts standby voltage. There is raw 150 volts, actually more like 160 volts. Haven't yet found any shorted or open components in regulator circuit. Any tips on what is the most common component failure with these symptoms. Thanks. |
All times are GMT +1. The time now is 08:21 AM. |
Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004 - 2014 DIYbanter