Home |
Search |
Today's Posts |
|
Electronics Repair (sci.electronics.repair) Discussion of repairing electronic equipment. Topics include requests for assistance, where to obtain servicing information and parts, techniques for diagnosis and repair, and annecdotes about success, failures and problems. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
#1
Posted to sci.electronics.repair
|
|||
|
|||
Mitsubishi VS-4543 looses picture
i got a call yesterday of a mitsubishi that had convergence gittering that
goes away when tapping the TV, and eventually but intermittently, the picture will go, but the sound stays working. Well, i went out there yesterday to service it, and it was reeked with bad solderjoints, so i resoldered the main board. the convergence gittering went away, and had a nice picture. it stayed on for a good 30 minutes or so. but i got a return call again today, saying the picture is still going black. she said the picture wont come back on unless the TV sits for awhile. She also mentioned that if the TV is left on with the sound playing, eventually maybe an hour or so, the picture will come back by itself. See that sounds like bad solder, but i already got most of that. the convergence has been fixed, but the picture still goes dead at random intervals, it could last an hour, sometimes 2, sometimes all day, then other times maybe 10 minutes. I went over the board with solder, so i know that cant be the issue. unless there is another board i missed somewhere. I did see a couple of riser boards on the mainboard, but i didnt get to those. Any ideas? anyone had this issue with this chassis before? |
#2
Posted to sci.electronics.repair
|
|||
|
|||
Mitsubishi VS-4543 looses picture
I found some info on this model for same problem. Assuming the on
screen display works (vertical IC OK), check/resolder yoke plug on all PCB's. Any one of these could cause this symptom. Obviously you could tap each connector to see if video comes back which points to defective plug. Good luck. |
#3
Posted to sci.electronics.repair
|
|||
|
|||
Mitsubishi VS-4543 looses picture
Resolder the connections at the yokes under the little gray cover on the
small PCB. Leonard "Mike" wrote in message ... i got a call yesterday of a mitsubishi that had convergence gittering that goes away when tapping the TV, and eventually but intermittently, the picture will go, but the sound stays working. Well, i went out there yesterday to service it, and it was reeked with bad solderjoints, so i resoldered the main board. the convergence gittering went away, and had a nice picture. it stayed on for a good 30 minutes or so. but i got a return call again today, saying the picture is still going black. she said the picture wont come back on unless the TV sits for awhile. She also mentioned that if the TV is left on with the sound playing, eventually maybe an hour or so, the picture will come back by itself. See that sounds like bad solder, but i already got most of that. the convergence has been fixed, but the picture still goes dead at random intervals, it could last an hour, sometimes 2, sometimes all day, then other times maybe 10 minutes. I went over the board with solder, so i know that cant be the issue. unless there is another board i missed somewhere. I did see a couple of riser boards on the mainboard, but i didnt get to those. Any ideas? anyone had this issue with this chassis before? |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
No Picture on Mitsubishi VS-4543 | Electronics Repair | |||
Mitsubishi TV snowy picture (WS-65313) | Electronics Repair | |||
Mitsubishi projection TV - no picture | Electronics Repair | |||
Mitsubishi VS-4543 PTV, blows fuse as soon as powered on | Electronics Repair | |||
Mitsubishi VS-4543 - In desperate need of help | Electronics Repair |