Help, how do I dry out wet camcorder?
 

Recently I took a JVC Hard Disk Camcorder model GZ-MG37U out near
the beach on a very stormy day. A huge ocean wave came up and threw
water all over us while the camcorder was recording. I wiped it
immediately. But later when I tried to tape something it said
"Recording Failure". When I put it in play mode only a few of the
indexes showed up. It won't play any "HDD Error! keeps showing up.
I was able to make it "Protect All" the files. It did it because I can
see the 'key' symbol in each index box. Most of each index boxes are
black. But they do show the date, time and quality setting when
trying to play them.

In record mode it shows what the lens is pointing at but then turns
itself off then on over and over. I was able to change the quality but
not get it to record.

I've performed the "Clean Up" operation on it. But it doesn't seem to
help. But will it help if I do it over and over?

BTW, the "Still Image Mode" is working perfectly. It plays and
records.

I know very little about hard drive Camcorder. What should I do to get
it working again?

Ben

Help, how do I dry out wet camcorder?
 

wrote:
Recently I took a JVC Hard Disk Camcorder model GZ-MG37U out near
the beach on a very stormy day. A huge ocean wave came up and threw
water all over us while the camcorder was recording.

[...]

I know very little about hard drive Camcorder. What should I do to get
it working again?

Ben

1. Claim on insurance policy.
2. Bank check from insurance company.
3. Buy new camcorder.
4. Buy water proof case for camcorder.
4. Be more careful in future.

Salt water often ruins powered-up electronics.

Help, how do I dry out wet camcorder?
 

wrote in message
oups.com...

wrote:
Recently I took a JVC Hard Disk Camcorder model GZ-MG37U out near
the beach on a very stormy day. A huge ocean wave came up and threw
water all over us while the camcorder was recording.

[...]

I know very little about hard drive Camcorder. What should I do to get
it working again?

Ben

1. Claim on insurance policy.
2. Bank check from insurance company.
3. Buy new camcorder.
4. Buy water proof case for camcorder.
4. Be more careful in future.

Salt water often ruins powered-up electronics.


This lot did a feature of dunking, powered up, in fresh water , non
waterproof kit , and a surprising number worked after drying out.
http://gadgetshow.five.tv/jsp/5gsmain.jsp?lnk=610
But i cannot find it in their archives

But otherwise seawater over powered kit is a near no-no for repair, next
down the no-no list after, even indirect, lightning struck kit

--
Diverse Devices, Southampton, England
electronic hints and repair briefs , schematics/manuals list on
http://home.graffiti.net/diverse:graffiti.net/

Help, how do I dry out wet camcorder?
 

wrote:

1. Claim on insurance policy.
2. Bank check from insurance company.
3. Buy new camcorder.
4. Buy water proof case for camcorder.
4. Be more careful in future.


Whoops - two No. 4s...

Help, how do I dry out wet camcorder?
 

And don't forget not to take your camcorder to Washington D.C. during the
raniy season!!!

Help, how do I dry out wet camcorder?
 

) writes:
wrote:

1. Claim on insurance policy.
2. Bank check from insurance company.
3. Buy new camcorder.
4. Buy water proof case for camcorder.
4. Be more careful in future.


Whoops - two No. 4s...

That wasn't deliberate, making them equally important? Or implying
that they are one and the same, if you keep it in a waterproof case
you are being careful?

MIchael

Help, how do I dry out wet camcorder?
 

wrote in message
oups.com...

Recently I took a JVC Hard Disk Camcorder model GZ-MG37U out near
the beach on a very stormy day. A huge ocean wave came up and threw
water all over us while the camcorder was recording. I wiped it
immediately. But later when I tried to tape something it said
"Recording Failure".

If it was mine I would dissolve sodium bicarb in warm water and then soak
the camcorder in that for a while. Then dry it out for two weeks and see if
it would run.

But it's a crap shoot either way. Keep them away from sea, salt and sand.

Help, how do I dry out wet camcorder?
 

Help, how do I dry out wet camcorder?
 

Help, how do I dry out wet camcorder?
 

The one Rule about wet electronics is not to power it up while wet.
Remove battery immediately, open any cavities and dry for a week. With
salt water, flush it out well first.


NT




If you get water in the optics or the hard drive (they're not
moisture-tight) those parts will probably be destroyed. Sal****er is
nasty stuff, you could try opening it up and washing the boards but it's
probably time for a new camera.

Help, how do I dry out wet camcorder?
 

On 16 Nov 2006 20:27:23 -0800, wrote:

Recently I took a JVC Hard Disk Camcorder model GZ-MG37U out near
the beach on a very stormy day. A huge ocean wave came up and threw
water all over us while the camcorder was recording. I wiped it
immediately. But later when I tried to tape something it said
"Recording Failure". When I put it in play mode only a few of the
indexes showed up. It won't play any "HDD Error! keeps showing up.
I was able to make it "Protect All" the files. It did it because I can
see the 'key' symbol in each index box. Most of each index boxes are
black. But they do show the date, time and quality setting when
trying to play them.

In record mode it shows what the lens is pointing at but then turns
itself off then on over and over. I was able to change the quality but
not get it to record.

I've performed the "Clean Up" operation on it. But it doesn't seem to
help. But will it help if I do it over and over?

BTW, the "Still Image Mode" is working perfectly. It plays and
records.

I know very little about hard drive Camcorder. What should I do to get
it working again?

Sal****er? Throw it away. It cannot be repaired.

If ever it happens in the future, immediately remove the batteries and immerse the item in a bucket
of clean fresh water.

Help, how do I dry out wet camcorder?
 

wrote in message
oups.com...
Recently I took a JVC Hard Disk Camcorder model GZ-MG37U out near
the beach on a very stormy day. A huge ocean wave came up and threw
water all over us while the camcorder was recording. I wiped it
immediately. But later when I tried to tape something it said
"Recording Failure". When I put it in play mode only a few of the
indexes showed up. It won't play any "HDD Error! keeps showing up.
I was able to make it "Protect All" the files. It did it because I can
see the 'key' symbol in each index box. Most of each index boxes are
black. But they do show the date, time and quality setting when
trying to play them.

In record mode it shows what the lens is pointing at but then turns
itself off then on over and over. I was able to change the quality but
not get it to record.

I've performed the "Clean Up" operation on it. But it doesn't seem to
help. But will it help if I do it over and over?

BTW, the "Still Image Mode" is working perfectly. It plays and
records.

I know very little about hard drive Camcorder. What should I do to get
it working again?

Ben


Salt water is death to electronics, it's corrosive and conductive. Unless
this is a very expensive camcorder then it may not be a viable repair.
Dunking it in water as some have suggested is not a good idea, don't even
consider it for a second as your problems will get much worse. Water will
contaminate the lenses/optics and cause serious problems. Also, this is a
hard drive based camcorder, water will enter the drive via the breather
holes and destroy it.

The only realistic hope of salvage is for a tech to dismantle it and wash
the electronics in distilled water or PCB cleaner solvent etc, thoroughly
dry out, reassemble and see if it works. One thing is certain, if it's left
as it is it will be ruined as the sal****er does its evil work over time!

The fact that the camera still has some functionality is promising however-
it may be a tiny amount of contamination causing leakage current between
adjacent PCB tracks or IC pins with no permanent damage. It will need to be
looked at very very soon though if you want to save it.

Morse

Help, how do I dry out wet camcorder?
 

On 16 Nov 2006 20:27:23 -0800, wrote:

Recently I took a JVC Hard Disk Camcorder model GZ-MG37U out near
the beach on a very stormy day. A huge ocean wave came up and threw

I wouldn't take good stuff, electronic or mechanical, anywhere near
the ocean, or other bodies of sal****er, even if I didn't get it wet.
If I didn't have a camera, I wouldn't have pictures anyhow.

When I had a sal****er aquarium, I would find salt on the out sides of
it and on the desk I kept it on, even though no one was touching the
tank except me, and I wasn't spilling any water.

I guess somehow it evaporates and condenses outside the tank. Isn't
there an expression, or did I make it up, about salt in the air?

I can't offer any helpful advice in this case, however. Sorrry

Ben


If you are inclined to email me
for some reason, remove NOPSAM :-)

Help, how do I dry out wet camcorder?
 

"mm" wrote in message
...

When I had a sal****er aquarium, I would find salt on the out sides of
it and on the desk I kept it on, even though no one was touching the
tank except me, and I wasn't spilling any water.

I guess somehow it evaporates and condenses outside the tank. Isn't
there an expression, or did I make it up, about salt in the air?

No, you are correct. I have seen audio CDs, stored about a block away from
the ocean, where the salt has corroded its way into the 'spiral groove' and
destroyed the CD.

Help, how do I dry out wet camcorder?
 

"Homer J Simpson" wrote in message
news:Siw8h.21255$C94.5016@edtnps82...

"mm" wrote in message
...

When I had a sal****er aquarium, I would find salt on the out sides of
it and on the desk I kept it on, even though no one was touching the
tank except me, and I wasn't spilling any water.

I guess somehow it evaporates and condenses outside the tank. Isn't
there an expression, or did I make it up, about salt in the air?

No, you are correct. I have seen audio CDs, stored about a block away from
the ocean, where the salt has corroded its way into the 'spiral groove'
and destroyed the CD.




One only has to observe the effects on cars which spend their lives near the
sea- they tend to rot quicker than cars that live inland.

Morse

Help, how do I dry out wet camcorder?
 

Morse wrote:
wrote in message
oups.com...
Recently I took a JVC Hard Disk Camcorder model GZ-MG37U out near
the beach on a very stormy day. A huge ocean wave came up and threw
water all over us while the camcorder was recording. I wiped it
immediately. But later when I tried to tape something it said
"Recording Failure". When I put it in play mode only a few of the
indexes showed up. It won't play any "HDD Error! keeps showing up.
I was able to make it "Protect All" the files. It did it because I can
see the 'key' symbol in each index box. Most of each index boxes are
black. But they do show the date, time and quality setting when
trying to play them.

In record mode it shows what the lens is pointing at but then turns
itself off then on over and over. I was able to change the quality but
not get it to record.

I've performed the "Clean Up" operation on it. But it doesn't seem to
help. But will it help if I do it over and over?

BTW, the "Still Image Mode" is working perfectly. It plays and
records.

I know very little about hard drive Camcorder. What should I do to get
it working again?

Ben


Salt water is death to electronics, it's corrosive and conductive. Unless
this is a very expensive camcorder then it may not be a viable repair.
Dunking it in water as some have suggested is not a good idea, don't even
consider it for a second as your problems will get much worse. Water will
contaminate the lenses/optics and cause serious problems. Also, this is a
hard drive based camcorder, water will enter the drive via the breather
holes and destroy it.

The only realistic hope of salvage is for a tech to dismantle it and wash
the electronics in distilled water or PCB cleaner solvent etc, thoroughly
dry out, reassemble and see if it works. One thing is certain, if it's left
as it is it will be ruined as the sal****er does its evil work over time!

The fact that the camera still has some functionality is promising however-
it may be a tiny amount of contamination causing leakage current between
adjacent PCB tracks or IC pins with no permanent damage. It will need to be
looked at very very soon though if you want to save it.


Indeed,Corrosion is building by the minute!
IMHO,It's probably hosed.
Insurance? Warranty?


Morse