 |
|
| Electronics Repair (sci.electronics.repair) Discussion of repairing electronic equipment. Topics include requests for assistance, where to obtain servicing information and parts, techniques for diagnosis and repair, and annecdotes about success, failures and problems. |
| Reply |
|
|
LinkBack | Thread Tools | Display Modes |
|
#1
Posted to sci.electronics.repair
|
|||
|
|||
Convenction Microwave dont cnvent anymnore.WHats broken ??
Iv'e been meaning to fix it for about a year and a half  I bough it to do just that. Roast chicken ect. Buts its busted. I seems to start convection and then cuts out after a while.. That might help you out trying to figure out whats the prob. I might get it fixed soon Thanks for any help. /pS The Microwave works fine, just not the convection part Bye. |
|
#2
Posted to sci.electronics.repair
|
|||
|
|||
|
Convenction Microwave dont cnvent anymnore.WHats broken ??
Odds are the temp sensor is faulty (very common for the leads to corrode inside
the cavity). There's inbuilt protection if the temp is too high/low for too long. The sensor is usually mounted on the side of the cooking cavity. On Fri, 28 Jul 2006 04:43:13 +1000, Home Theatre Guy Home Theatre Guy wrote: Iv'e been meaning to fix it for about a year and a half I bough it to do just that. Roast chicken ect. Buts its busted. I seems to start convection and then cuts out after a while.. That might help you out trying to figure out whats the prob. I might get it fixed soon Thanks for any help. /pS The Microwave works fine, just not the convection part Bye. -- Australia isn't "down under", it's "off to one side"! www.cobracat.com (home of the Australian Cobra Catamaran) http://groups.yahoo.com/group/cobra-cat/ |
|
#3
Posted to sci.electronics.repair
|
|||
|
|||
|
Convenction Microwave dont cnvent anymnore.WHats broken ??
I supose this ain tan expensive part Though to opene dit up and install it would cots a bit. It was a 900 Microwave so i think a repair would be better. Thanks for the info. On Fri, 28 Jul 2006 19:01:34 +1000, Stan Blazejewski wrote: Odds are the temp sensor is faulty (very common for the leads to corrode inside the cavity). There's inbuilt protection if the temp is too high/low for too long. The sensor is usually mounted on the side of the cooking cavity. On Fri, 28 Jul 2006 04:43:13 +1000, Home Theatre Guy Home Theatre Guy wrote: Iv'e been meaning to fix it for about a year and a half I bough it to do just that. Roast chicken ect. Buts its busted. I seems to start convection and then cuts out after a while.. That might help you out trying to figure out whats the prob. I might get it fixed soon Thanks for any help. /pS The Microwave works fine, just not the convection part Bye. |
| Reply |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Convection Microwave. But the Convenction cuts out any ideas ?? | Electronics Repair | |||
| Samsung Microwave & GE Microwave oven | Electronics Repair | |||
| microwave door replacement | Home Repair | |||
| Microwave broken, repair or replace | Home Repair | |||
| Sparking vegetables in microwave | Home Repair | |||
Linear Mode
