Home |
Search |
Today's Posts |
|
Electronics Repair (sci.electronics.repair) Discussion of repairing electronic equipment. Topics include requests for assistance, where to obtain servicing information and parts, techniques for diagnosis and repair, and annecdotes about success, failures and problems. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
#1
Posted to sci.electronics.repair
|
|||
|
|||
CTC 169 Proj.
Set had shorted u4101, Q4101 and open 1.8 Ohm resistor in power supply.
Changing these and caps and diodes in this area returned standby to143 volts at cr4116. Changed cr4118, voltage at 13.6. When turned on, standby voltage will drop off. Horizontal output will start for about a second and shutdown. Have checked HOT and seems OK. Have remove lead wire to HV splitter with no difference. Secondaries off the flyback start but do not reach full voltage. Pins 4, 5, 7, and 9 are at ground . Is this normal? Any suggestions? |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Mitsubishi Proj. model VS6043A (4 of them same strange problem) | Electronics Repair | |||
Repost: Pioneer proj. model SD-P452 no sound desperately seeking schematic | Electronics Repair | |||
Pioneer proj. model SD-P452 no sound | Electronics Repair | |||
Sony proj CRT | Electronics Repair | |||
RCA Model P61830BL (Chassis PTK 195 BT) Proj. TV standby power problems. | Electronics Repair |