Home |
Search |
Today's Posts |
|
Electronics Repair (sci.electronics.repair) Discussion of repairing electronic equipment. Topics include requests for assistance, where to obtain servicing information and parts, techniques for diagnosis and repair, and annecdotes about success, failures and problems. |
|
LinkBack | Thread Tools | Display Modes |
#1
|
|||
|
|||
Problem with the STK465 ( B or A ... ? )
I got a problem with the STK465.
The device I tried to replace was marked STK465 with a B on. ( that one is defective. ) The new one is not marked with the B, just STK465. When I measure the voltage at pin 4 and pin 13 with respect to ground, I got between +3.5 to +4 volts. On the STK465 B I got -1.4 volts, what I did expected to measure according to the internal schematics. I have tryed with 2 STK IC's, and they both get about the same readings. Output (pin 7 or 11) from the amp. is very distorted. It clips at the negative half wave at low levels. At full power it looks like crossover distortion on the oscilloscope. Is there any difference between the "old" STK465 B and the new STK465 that I get from the shop today ? Anyone have some suggestions? |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Outside drain problem... Who is responsible? | UK diy | |||
SONY 35" Dual PIP -Video Blackout Problem | Electronics Repair | |||
Paslode IM250A Cordless Finish Nailer, Stripped Treads Problem | Woodworking | |||
Widespread problem with HP Omnibook XE3-GFs? | Electronics Repair | |||
Problem with retrace lines on EIZO F55S... | Electronics Repair |