HP / Agilent 8160A Pulse Generator
Hey,
I have a puls generator mentioned above. The settings for the impuls frequency and width and so on work fine but there is a problem. If I set the the impedance on 10kOhms I only get 4V amplitude instead of 19.99V and at 50 Ohm there is only 200mV instead of 9.99V. I have not found anything to change this behavior! Also there is shown an error message "PARAM" if I press the High Level (HIL) botton or the Low Level (LOL) botton. The DC-voltage is on the 0-line at about -7.5V and oscillate 300mV up and down. If there is someone who knows what is wrong please let me know! best regards Peter |
All times are GMT +1. The time now is 01:01 PM. |
Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004 - 2014 DIYbanter