My ProView Model 780 flat screen LCD monitor
quit one day while being used.

The 12v supply is still good, and getting to the monitor, as indicated
by the little green LED lite on the power switch on the front.

A guy in this group helping me said a common failure mode in these is a very
small
fuse inside the case. Makes sense. I was going to check this fuse,
and attempted to take the monitor apart to gain access. Then, I got
interrupted and had to focus on other things. I'm now back to the
monitor project.

I got the back of the case off, no problem. But, I didn't spot
anything that was obviously a fuse at that point. So, I assumed I
would need to lift up the board at the bottom, and maybe even the LCD
panel.

Anyone know where the fuse is likely to be, and what things I'll have
to take apart to find it?