"Steve R." wrote in message
...
"Tom" wrote in message
...
JWho wrote:
Hi. I have an aluminum piece with a hole. There was a tube pressed
into
that hole, but I pressed it out and want to install a different tube.
The
inner diameter of the hole is slightly larger than the new tube that I
want
to press fit into the hole. The new tube can be inserted into the hole
without a press fit, but it does not rattle around. This is not a
tight
enough fit. It has to be a press fit. I am hoping there is a tool to
reduce the inner diameter of the aluminum hole so that the new tube is
a
tighter fit. From searching around, it seems that I may need a
knurling
tool. I have a 20 ton shop press, and I am hoping to find something
that
I
can press through the hole to make it a smaller hole, causing a press
fit
for the new tube and aluminum piece.
Does anyone have any suggestions on what to do?
Sorry to not list a real e-mail address, but it is to avoid spammers.
It
is
goteverwhatyouneed at yahoo dot com.
Thank you very much.
http://68.72.74.108/PRODUCTS/660.htm
Tom
or Permatex 620 sleeve retainer.
Hi. Thank you both for the suggestions. I am going to take some pictures
of all the items and give some dimensions in a later post.
Thank you.