"JWho" wrote in message
news:hQy4f.439523$x96.344304@attbi_s72...
Hi. I have an aluminum piece with a hole. There was a tube pressed
into
that hole, but I pressed it out and want to install a different tube.
The
inner diameter of the hole is slightly larger than the new tube that I
want
to press fit into the hole. The new tube can be inserted into the
hole
without a press fit, but it does not rattle around. This is not a
tight
enough fit. It has to be a press fit. I am hoping there is a tool to
reduce the inner diameter of the aluminum hole so that the new tube is
a
tighter fit. From searching around, it seems that I may need a
knurling
tool. I have a 20 ton shop press, and I am hoping to find something
that I
can press through the hole to make it a smaller hole, causing a press
fit
for the new tube and aluminum piece.

Does anyone have any suggestions on what to do?

Sorry to not list a real e-mail address, but it is to avoid spammers.
It is
goteverwhatyouneed at yahoo dot com.

Thank you very much.


Swage the end of the tube to a larger size to fit in the hole properly.



----== Posted via Newsfeeds.Com - Unlimited-Uncensored-Secure Usenet News==----
http://www.newsfeeds.com The #1 Newsgroup Service in the World! 120,000+ Newsgroups
----= East and West-Coast Server Farms - Total Privacy via Encryption =----