high voltage mica caps aren't hard to find, I have a 30,000 VAC mica cap
sitting here at this moment - it's about 8 inches X 6 inches X 12 inches,
with a 8 inch insulator on top, the case is one terminal, the other is on
top of the insulator.

I suspect your TIG welder needs a lower voltage.

Mica has particular dielectric benefits in certain frequency bands - and oil
dripping out is not a real problem, jsut remove the cap, refill with oil and
seal it again. use mineral oil if you can't find capacitor oil.


" They are mica capacitors. Can types other than mica be
used? And can they be paralleled to increase the value? Is there a
better type than mica? And finally, does anybody here have some to
sell?
Thanks,
Eric R Snow