On Wed, 12 Oct 2005 23:49:35 +0100, Martin Carroll
wrote:

They are in need of some tlc and I was wondering what the
best method was of cleaning them up.

Is the surface of the stone dressed (ashlar) or rough ? If it's rough,
then use a long bristled phosphor bronze wire brush (looks like a
paintbrush, Axminster sell them). Wrap masking tape around it to
stiffen (i.e. shorten) the bristles, if needed.

For dressed Bath stone, then a Plasplugs mesh tile file (any B&Q) or
coarse silicon carbide wet and dry paper stuck to a hard backing board
(plywood with 3mm polyethylene floor underlay foam).

There are a few chips in the edges so It might be an idea to try and
chamfer them. Is this an easy job to do, what is the best tool for the
job.

Tile file - a rigid carbide grit covered one (Plasplugs from the B&Q
tiling shelf again)

is there any way of filling this hole sympathetically?

Smooth the hole round, then fill it with a turned stone bung. This is
easier if you live around Bath though (how big is it?)

You can saw this in two halves, if you need to fit over a pipe.
"Turning" is just a matter of unpowered centers to support it and the
tile file (or maybe an abrasive disk) used as a toolpost grinder.


--
Cats have nine lives, which is why they rarely post to Usenet.