View Single Post
  #12   Report Post  
Doctor Drivel
 
Posts: n/a
Default


"Christian McArdle" wrote in message
. net...
2) The boiler is not designed to take luke warm let alone hot water as
it's input.


But I suspect most boilers would cope for the minute or two operation
period.

That is where the pipe stat and the timer comes in I suppose. Once the
loop is up to temperature it kills the pump and allows it to return to
heating mode. The big problem will be the heat capacity (or more the
lack of it) of the pipework - it will get cold quickly.


It only needs to be on for about one minute to heat the loop. Then the

loop
will stay hot for many minutes with a high hysterysis thermostat

satisfied.
Obviously any secondary circulation system would have to be very well
insulated. This applies to all types.

It will still cycle the boiler much more than a storage based system,


On what do you base this article of faith?

though. However, I don't see this as a show stopper, just a disadvantage.

6) The water bylaws
forbid the permanent connection of the mains to a closed circuit.


I can't see how this applies to secondary circulation loops. They aren't
really closed loops.


Yep, you are right.

If a house needs a secondary loop it also needs a grown up heating

system
that will include a stored HW of some type (vented, unvented or thermal
store).


Indeed ;-)


Whilst I'm no fan of permanently on secondary circulation loops in most
cases due to energy efficiency reasons,


6 of 1/2 dozen of the other. You save a hell of a lot in water wastage
which on a meter you pay for. Then the convenience. Most people who use
the front door toilet (cloakroom) very rarely wash their hands in hot water,
because of the long lag.

I can see the benefit of a manually
operated (i.e. 2 minute timed) system in a domestic property, as it would

be
very effective at water conservation. A manually operated system would

also
actually save energy, as the reheated water will start at a higher
temperature than fresh mains.


I have seen a pump on the DHW draw-off pipe activated by a flow switch.
This pumps out water from a cylinder pronto reducing the lag