"Mike Pio" wrote in message
news:mCC_e.14178$GQ4.4531@fed1read05...
I'm building cabinets for my kitchen and the design calls for some 45
degree corner cabinets. These will go at the end of a line of cabinets
(both base and wall). I'm using soft maple face frame construction and
plywood boxes. Before I re-invent the wheel, can you offer any tips/tricks
on the face frame construction for this type of cabinet and attaching the
carcass to the face frame? Is the face frame for a corner cabinet the
same as a standard cabinet, just cut the dadoes at a certain angle?

I would build the last regular and 45 degree cabinet as one unit. You can
easily make the 45 degree transition by using a 45 degree edge butted up to
a 90 degree edge and pocket holing the pieces together. The result will
hide the corner joint of the face frame. I can post a picture of a similar
setup if you like.