If you do need to remove the baffle or trim from the ceiling, you should be
clear as to what is holding it in. There are several types of retaining
mechanisms so yanking on it may cause more harm than good





"kj" wrote in message
...



I was doing a routine lightbulb replacement in the recessed ceiling
fixture in my entrance hallway when the top of the bulb sheared
off cleanly from the threaded metal part. Great.

I yanked off the bulb, but now the metal part is stuck in there,
so I have a useless fixture. This would be a pain under any
circumstance, but the fact that the socket is recessed makes it
impossible to stick a pair of pliers in there to attempt to unscrew
the metal part.

The housing for the fixture is attached to the socket, so even if
I managed to pry it out, I still would not be able to access the
socket with pliers. I suppose I will have to pull the housing out,
cut the wire, and replace it with a new housing, splicing the wire
coming off the new housing into the cut end.

Am I on the right track here? If so, what do I have to do to remove
the housing. After working at it for a while I didn't get very
far at all. One would think that one has to rip the ceiling to
get that housing out, but I can't believe the system would be that
stupid.

How does one fix a situation like this, without ripping out a big
chunk of ceiling?

Thanks!

kj

--
NOTE: In my address everything before the first period is backwards;
and the last period, and everything after it, should be discarded.