I've seen more sockets chewed up by folks using needle nose pliers on them
and I've yet to meet a person that successfully used any type of vegetation.
A very easy and reliable method is to turn off the power and unscrew it with
a diagonal pliers. It fits right into the socket, grabs the edges neatly and
spins it right out



"RicodJour" wrote in message
oups.com...
kj wrote:
I was doing a routine lightbulb replacement in the recessed ceiling
fixture in my entrance hallway when the top of the bulb sheared
off cleanly from the threaded metal part. Great.

I yanked off the bulb, but now the metal part is stuck in there,
so I have a useless fixture. This would be a pain under any
circumstance, but the fact that the socket is recessed makes it
impossible to stick a pair of pliers in there to attempt to unscrew
the metal part.

The housing for the fixture is attached to the socket, so even if
I managed to pry it out, I still would not be able to access the
socket with pliers. I suppose I will have to pull the housing out,
cut the wire, and replace it with a new housing, splicing the wire
coming off the new housing into the cut end.

Am I on the right track here? If so, what do I have to do to remove
the housing. After working at it for a while I didn't get very
far at all. One would think that one has to rip the ceiling to
get that housing out, but I can't believe the system would be that
stupid.

How does one fix a situation like this, without ripping out a big
chunk of ceiling?

The baffle/reflector goes in after the fixture itself. Since the bulb
is gone, it's easy to remove the baffle, then you should have enough
room to get a needlenose pliers in there.

R