Ignore this poster. It's a troll.


Van Chocstraw wrote:
Sam Goldwasser wrote:
snip
I'm using exactly that monitor now. It's a great monitor.

Given your symptoms, I'd first suspect a bad connection in the AC
input or
power supplies, or just a loose power cord. In my experience, these
are
very reliable monitors. The only problem I've seen among three of
them was
a dried up capacitor in the vertical output which resulted in only
half a
picture.

Do follow the safety advice though!!!

--- sam | Sci.Electronics.Repair FAQ Mirror:
http://repairfaq.ece.drexel.edu/
Repair | Main Table of Contents:
http://repairfaq.ece.drexel.edu/REPAIR/
+Lasers | Sam's Laser FAQ:
http://repairfaq.ece.drexel.edu/sam/lasersam.htm
| Mirror Sites: http://repairfaq.ece.drexel.edu/REPAIR/F_mirror.html

Sam, I see you are the author of the FAQ. You are to be commended
for a
fine bit of work. I managed to get the main board out safely and am
starting to examine things more closely.

I have a comment regarding the Sony service manual for the
CPD-200GS.
On page 2-2 it recommends shorting the anode and the anode cap to
chassis ground or aquadag AFTER removing the anode cap! What's more
there's a diagram that indicates one should NOT slide a screwdriver
under the rubber cap.

Sony's been making CRTs for a long time so it seems strange they
would
recommend a dangerous procedure like that. Any cracks or pinholes
in
the rubber and you could wind up getting quite a jolt.

VCS