See if you can obtain an identical drive, including checking the
firmware version numbers. If so, you may be able to swap the controller
board on the hard drives.

- Jerry


GHZpc wrote:
I accidently broke Pin #1 on my Maxtor hard drive. Unfortunately, I had very important data that was not backed up. Yes, I have already learned my lesson.

The pin broke off so deep that there is almost no metal visible to make contact with. I tried a safety pin and attempted to use my average soldering skills to solder a new pin in place. I have still had no luck up to this pont.

I think my best bet (besides buying a new hard drive), would be to remove the daughterboard on the outside of the hard drive and then have more access to where pin #1 is located. Does this sound like a safe thing to do? I would have to be aware of any small thin cables sticking out of the hard drive so that they do not get broke too.

If you have any other suggestions, they would be greatly greatly greatly appreciated. And please, please tell me that there is still hope. After all, it's only one pin. I refuse to believe that an entire hard drive can be useless just because one pin broke.


Thanks for your replies.


--------------= Posted using GrabIt =----------------
------= Binary Usenet downloading made easy =---------
-= Get GrabIt for free from http://www.shemes.com/ =-