Haven't you heard of turning the needed part in an engine lathe?

"Martin Whybrow" wrote in message
...
I have a well used Startrite Mercury drill press that has excessive play in
the quill; the bearings are fine but the journals that the quill runs in
are
worn (specifically the lower one). I had planned to bore out the journals
oversize, press in 2 short lengths of cast iron tube and then bore again
to
the correct size for the quill. The problem I've encountered is that I
can't
locate any CI tube the right size, it needs to be 40mm (1 5/8") ID and
46mm (1 7/8") OD. I can get phosphor-bronze solid with a suitable OD but
not sure if this will wear well in this application.
Any suggestions?
Martin


--
martindot herewhybrowat herentlworlddot herecom